Guitar Cradle

01

Mark the hook positions

Using a pencil, to mark 3 places on the body where you want to intall the hooks.

02

Mark the drill holes

Using the supplied template, align the template's line with pencil line and mark the 2 holes for each hook.

03

Drill holes and install the anchores

Using a drill and 3/16 inch bit, drill the 6 holes marked in step 2 and insert the supplied anchors.

04

Insert the screws

Insert the 6 supplied screws in the anchors leaving a little space. Use the thickeness of the supplied template as a guide of how much space to leave.

05

Insert the hooks

Align the keyholes of each hood with the screws and slide it down. If the hook is not sliding in then increase the height of the screws a little until you can slide the hooks.

06

Adjust the height of screws

Tighten the screws as much as possible and use light tapping to slide down the hooks so they're tight against the wall.

07

Place the guitar

Once the 3 hooks are installed, place the guitar and enjoy!

created with

Website Builder .